Posts

Chosen Solution Title says it all. Late 2013 MBPr froze up while using it yesterday. I diagnosed it as best as I could. It boots just fine from a USB drive. The screen, keyboard, and trackpad all work. But the MBPr doesn’t “see” its internal SSD, Thunderbolt 2 external devices (eg, external HDD, TB2 to Ethernet dongle). And the WiFi is completely MIA. I verified that the MBPr thinks all this hardware is “missing” via System Profiler while booted via USB....

Chosen Solution Hi, So I purchased a new ASUS laptop just last week. My control panel says it is model X555UA. It came with 4gb of RAM, but I upgraded to 8GB of ram in the store when I bought it. It has been great, except the last few days while I am using it, the screen will go black and the laptop will just stay black for a few minutes, then my log in page appears....

Chosen Solution Is there a way a Buffalo DriveStation (2TB), which I use for recording TV programs, can be optimized or defragged? I’m having the same problem as the last DriveStation (1TB) I replaced with this one and I was wondering if there was a way to fix it. The problem is that it doesn’t always record programs to their completion and/or there is bad pixilation interspersed on some shows I record,(but not all)....

Chosen Solution I have Lenovo S6000H with broken LCD, but I can’t find cheap enoung LCD replacement parts. If I order S6000 model LCD part, will it fit in? Is it compatible? Yes you can change as the specifications are same and being of the same model make the ports should be same

Chosen Solution While in the camera, the portrait looks fine and the bokeh shows in real time but when I capture it the background blur just becomes normal. Is this a camera problem? It’s most likely just a software problem so try doing a full reset on the device and see if that helps. Remember to make a backup of your phone.

Chosen Solution My car gears are popping out , different ones at different times , today I only had 1st, 3rd and 5th most common issue is normally low or contaminated fluid. the synchronizers could also be worn or the linkage not adjusted properly, I would check the fluid first and hopefully that’s all it is.

Chosen Solution Hello, I have 2008 hyundai elantra and it is starting to give me hard time. The driver side and rear driver side windows work fine. However, passenger side and rear passenger side windows are experiencing problems. They go down just fine, but when I try to roll it up I have to hold the switch up for a while (sometimes up to 10+ minutes) while driving And yesterday, my front passenger window finally died on me and never came up....

Chosen Solution Printer won’t print black. All other colors work. Gone through all the tasks ie: clean printhead, alien, ???? Have you tried to print a print quality test page? It is in Setup-Reports. It will print a few tests, the one to check is the block print for each color. If the black block is light, white stripes or missing altogether then replace the Black/Yellow print head (not ink cartridge)....

Chosen Solution “hey. my Acer Aspire V5 431 cant boot up.. i think tis disk has been fully clean.. and i cant even use my win7 installation DVD to boot up.. it always display, “BOOTMGR missing”” Hello mastermindmi7 Press F2 when power on the notebook and you will see BIOS Change the Boot order as 1st : Optical Drive 2: HDD restart the notebook with OS DVD you can install new OS or if you having recovery option you can recover the notebook back...

Chosen Solution Hi All, Apologies for a question that is no doubt asked here pretty frequently… Im about to replace the Hard Drive, RAM and Battery on a pretty knackered Macbook Pro 2009 - this is my first time doing this and I’m not much of a tech wiz - I have a couple of questions… Other than the guides on here (which I plan to follow) - can anyone offer any further advice - i’m thinking mostly about what happens once everything is (hopefully) successfully replaced and I boot up for the first time… is there a specific page for that that I have missed in my searches?...

Chosen Solution Hey, my iphone 7 plus back camera stopped working so i replaced the back camera only. after installing it i realized that my front camera is not working anymore it is showing Black screen. i tried to reset the phone turn off and on , also tried to put a new selfie camera and test it and it also didn’t work. at the end i decided to factory reset the whole phone, and also didnt work....

Chosen Solution I spilled water on my macbook, and than the keyboard started acting funny, some keys were not registered. After replacing the entire topcase the problem is still there. What can it be? One of the main items on a MacBook Pro to go out after water damage is the keyboard and keyboard connector. If you have already replaced the entire top-case, that would lead me to believe it is the keyboard connector that is damaged, blown, or corroded still....

Chosen Solution So my gf spilled some juice on her Macbook Air and we took it to a place where they supposedly cleaned the pieces to remove corrosion, the problem was that when you turn on the macbook, the screen turns itself off for a flash or the macbook enters in hibernate mode by itself randomly but when I got it home, I opened the computer and removed the I/O cable and the computer worked without any problem (besides the fan running at a 100% and the kernel task issue) so, after that I realized that the problem was either the i/o board or the i/o board cable, I would like to add that if I disconnect the battery and the i/o board cable I can use the computer without the main trouble of it entering in hibernation or the flashing screen but with the same kernel task + fan at 100% issue so, I dont know if I should change the I/O board or the cable itself...

Chosen Solution My fonepad if battery is empty 0% tab will not be opend again and can not be recharged problem be solved only after battery recharged manually what can i do I have this problem open tablet, disconnect battery, reconnect, charge..

Chosen Solution Hey! How are you? I want to know why this battery has 2 black cables, 2 red cables and 1 white, because i wanted to put another kind of battery that only has 1 black cable and 1 red cable Hey! Cómo están? Quiero saber por qué esta batería tiene 2 cables negros, 2 rojos y 1 blanco, porque le quería poner otra batería que tiene sólo 1 cable negro y 1 rojo...

Chosen Solution BAUHN 65inch 4K UHD LED LCD Smart TV - Loud POP and now no POWER? Hi There, Two weeks ago while watching TV, we heard a POP noise from the back of the TV and then we lost all power (no red/stand-by light since). I need some help to determine whether this silly TV is repairable at a reasonable cost. Its not even 3 years old yet and had only one year warranty....

Chosen Solution How do I replace the ground drive belt on my 25hp, 48" cut, Craftsman Lawn Tractor mod.917.276020 David, this from the manual: “TO REPLACE MOWER DRIVE BELT MOWER DRIVE BELT REMOVAL Park tractor on a level surface. Engage parking brake. Lower mower to its lowest position. Remove screws from R.H. mandrel cover and remove cover. Remove any dirt or grass clippings which may have accumulated around mandrels and entire upper deck surface....

Chosen Solution Hello, Suddenly my macbook pro not working as expected. Connecting power cord auto starts the macbook but with black screen, fan running, battery being charged, no light in keyboard, backside apple logo light works. charging phone using usb cable working. Tried smc reset and its working but pram reset not working as i am not able to see any restart or chime during pram reset. Tried external display but it seems not connected to display....

Chosen Solution Hi, I recently bought a second hand fat ps3. When I go to turn it the light first goes green the quickly to blue then to yellow and then finally blinks red. I looked online and saw that changing the thermal paste might work, which I’ve done but the same lights still happen when I press the power button. Any help would be appreciated. maybe this can help. Fixing Playstation 3 Green Light of Death (GLOD)

Chosen Solution my galaxy note 10.1 is not working because it was broken micro usb port for charging. so where can I repair it in anchorage? or how can I repair it in anchorage? Hi, The charging port isn’t soldered to the main board. Replacing is easy, because the charging port is on the flex cable. Look here step 15, pic. 2 Samsung Galaxy Note 10.1 Teardown But you must have some experience to disassemble the Touch screen & LCD display module....