Chosen Solution Hi, i have an Wiko Rainbow Special Edition and i can’t seem to conect to the wifi networks. I already did a factory reset and when it try’s to conect it says “Out of Reach” even though i am near the router and it asked for the wifi password and it autenticated sucessfully. plz try flash with firmware …… i hope working……thanks
Chosen Solution Does 2x3 Inch ZINK Photo Paper for Pogo Cameras and Printers work with the polaroid snap instant digital camera? Yes, any 2x3 inch Polaroid ZINK Photo Paper should work with the Polaroid SNAP device. If you are having difficulty getting your Polaroid SNAP to print photos, please refer to the “Picture Will Not Print” section of the Polaroid SNAP Troubleshooting page. Yes you can use either Zink PoGo paper or Zink Premium photo paper....
Chosen Solution New post since I didn’t solve the problem ———- Took apart my DS to switch something inside, now it won’t turn on and is 100% dead unless I hold the battery a certain way and push it in the battery piston thingys. When I place it in the housing it shuts down. Why is this happening? I haven’t used this 3DS for more than a year-2 Max so i don’t think the battery is the problem....
Chosen Solution The thing is: I messed it up. I tried to put a transparent shell on my joycon and the right one now can only work attached to the switch. I’ve already cheked the battery and it’s working fine. I think it’s something related to the motherboard, but I can’t tell for sure. Someone here have a better understanding about the joy con circuit? Cheers mate. Not sure if it’s the same issue I had, but in my case the SL button wasn’t connected to the joy cons mainboard....
Chosen Solution hello every body i have 407 2.0 hdi with EW10A motor The flasher lights always stay on and do not go out even when the car is off. I have airbag error too and error that all dors and trunk is open Although they are closed. The brake lights are also on when the switch is opened No error is displayed when I turn on the PPS or other diagboxs....
Chosen Solution How to dial with out having to change fromT9 to ABC on a Alcatel One Touch Phone Model # 10188? Predictive text (or T9) is usually turned off by holding * or # for few seconds, or you may need to go to dialer settings and turn it off there
Chosen Solution Hi, Had a xr with badly cracked glass on the back. I got new housing and have replaced it. I used all the original parts from the xr, following guides on ifixit and keeping all screws etc in place . Everything works like it should including wireless charging but apple pay wont work. It comes up to pay but wont talk to the card reader. No error msg comes up , it’s just like the card reader ain’t there....
Chosen Solution mine is a Dell Inspirion and its saying the exact same thing. I was told it was a hacker who was remote controlling my laptop…I need it fixed to get them out. I have tried everything. Is there s way to factoryvreset around this??? It’s possible that a hacker encrypted your hard drive and put a password on it. Have you received any messages demanding money to get the password?...
Chosen Solution I replaced the belt with a brand new one but still happens. Any ideas? @sunsetblow check under the platter. There should be two holes (marked 33 and 45) Use a small flathead screwdriver to make some fine adjustments. Of course, you also want to make sure that the belt is properly installed and not riding to high on the pulley.
Chosen Solution My galaxy A3 this morning turned off on 10% battery.When i put in charge it just said 0% and charging.I reset it,and it has been charging for past 5 hours but still 0%. Can it be fixed ? dino.imamovic93, Reset did not work, either the cable or charge port may be damaged. Look in the charge port and blow/pick out(carefully) any dust/debri that may be causing an issue. Try a different compatible charger/cord to see if that is the issue....
Chosen Solution Good day, I replaced the front screen on this iphone 6 and it will not charge when the screen is on, when I open the phone (not taking the screen totally off) it charges like a hot darn. The minute I close it, no charging. What did I do wrong here? Good friends, you can check if your terminal is somewhat bent? this can make the screen and even the motherboard behave strangely, I happened to me with the same model terminal very recently....
Chosen Solution Followed the battery replacement guide - turned on and worked great - for 4 hours or so - now I can’t get it to boot up past the Macintosh chime, but can hear the fans very quietly spinning. I tried the SRC reset and the nVRAM reset with no success. Does anyone have any ideas? Best, Patrick is the connector from the battery to the logic board connected properly?...
Chosen Solution Hey! After trying to install a custom rom to my nexus 7 it just get’s in boot loop. I was then gonna reset it to factory rom. 5.1.1 and while doing “fastboot -w update image-nakasi-jdq39.zip” the USB cable accidently got ripped out while updating. So everything lost connection and now i am stucked with a boot loop on google logo and I cana not get into the nexus 7 via USB....
Chosen Solution Hello everyone, my problem is really weird, because i disassembled my controller to repair it, and when i reasambled it the joysticks started to not working properly, and all the games i played when i use the joysticks, the movements arent being fully detected. For example, when i move the left joystick up to run in a game, the game just read it like i am tapping it to walk....
Chosen Solution iMac 14,4 : 21.5 inch : mid-2014 Over the weekend I upgraded the HDD in my iMac to an SSD. This requires removing the screen, which is glued onto the enclosure. As part of the re-assembly process, I cleaned the old adhesive with 91% isopropyl alcohol, applied new adhesive strips (LeFix, not iFixIt, please forgive me), and put everything back together. For 3 days, everything was fine. This morning, there was an irregular spot on the inside of the upper-right corner of the screen....
Chosen Solution While Cleaning out an old PS2 i scored from the Pawn Shop I managed to damage the ribbon cable clip that hold the larger ribbon cable coming from the DVD drive. I was able to find Motherboards online pretty reasonably priced. Can I just swap in a new one or is it tied to the DVD drive? Thank you, bOOmingraNNy99 Spent some time researching, doesnt look as though it is requiring serial numbers to match on any other internal parts....
Chosen Solution Where is the cabin air filter located on my 2000 jeep grand cherokee? @holbrooks all 1999-2004 Grand Cherokee WJ series models feature a housing for installation of a cabin air filter but no models have ever come with the filter as standard. It must be purchased as a Mopar aftermarket accessory and installed under the front cowl. So unless you had it installed, there isn’t one. There isnt one unless an after market filter has been installed....
Chosen Solution My frontal cam has grey spots on it, not the back one, just the front https://ibb.co/cC56p5 try and clean the upper surface. If it doesn’t work use alcohol. There may be 2 options besidesthat: The spots are under the glass The spots are on the sensor itself in which of both cases it will require a disasembly.
Chosen Solution Hello, I have an NX 1000. It has been in storage for some time. Went to use is and the camera gives me the same message when i load an SD memory card, I have tried a couple diffenet cards and also tried formatting a card from an online program. Nothing working. Do I need a Samsung SD card? What cahn you suggest. Cheers, Bo Bo Weeks you do not need a Samsung card....
Chosen Solution hello guys yesterday i replaced the battery and the dockconector on my iphone 6 because there was some short circuiting going on. after that my phone worked fine except for both cameras, the flash and the earspeaker. the proximity sensor works fine though. does anyone know a fix? kind regards jonas liquid damage? take a look iPhone 6 rear camera and flash not working Update (27.09.2016) what kind of short circuit made you change the battery?...
